Description
Suffix EP MB 300 is 2 component transparent casting epoxy resin. Its crystal clear liquid and its designed to be used in flat surface casting such as on tables, coffe tables, kitchen tops and etc.
Areas of Use
Suitable for River Tables, Coffee Tables, Ocean Waves, Kitchen Tops, serving boards, solid wood, MDF molds, small decorations and other castings from 1 cm up to 3 cm.
Advantages
Its crystal clear, contains UV additives, can be coloured with different pigments, its perfect for casting from 1 up to 3 cm and can be used on all surfaces like wood, concrete and glass. Suitable for excellent visual properties.
Technical Properties
- Volume – 100%
- Viscosity – 400 – 600
- Density – 1080
- Hardness (Shore D) – 80
- Thermal Resistence – 75 °C
- Mixing Ratio – 100:45
- Curing Time – 12 hours
- Demolding Time – 2 days
- Full Curing – 7 days
Preparation
To achieve perfect results, the mixing ration must be applied correctly. Changin the mixing ratio causes the surface ro not dry properly and not reach its full mechanical properties. Its essential to use scale while preparing the mixture.
The application surface must be solid. Ambient temperature should be 18-23 °C and humidity should be below 50%
Application
45g of component B must be mixed with 100g of component A by weight. When weighing, component B should be weighted first and then component A should be added to it. To obtain a homogeneus mixture, the components must be mixed thoroughly at low speed for 15 minutes, at the 10th minute you could add the colouring pigments. After that should be left for 30 minutes for the bubbles to dissapear, then it should be mixed again for 3-5 minutes and the Resin will be ready to be poured into the mold. The system tends to heat up in the container it is mixed in. Only the amount of product needed to be applied should be mixed. The maximum amount to be prepeared at one time is 10kg.
Before the application you need to make sure the mold in which the epoxy will be poured has leakeage isolation.
If layered casting is to be done, after the first layer is poured at 20 °C, wait 16-20 hours and check the epoxy by hand contact. Once the soft but non-adhesive condition is detected, the second layer can be poured.
Storing and Shelf Life
It should kept tightly at room temperature, protected from sunlight. The Resin should be at 22-25 °C. Keeping the epoxy at lower temperatures causes crystallization and in this case a clear mixture cannot be obtained. If the Epoxy Temperature is below 10 °C, the temperature of the material should be carefully increased to 22-25 °C with a water bath in the container
It can be stored in its unopened original containers for 1 year from the date of production. Material in opened buckets should be used immediately.
Consuption
(A+B) – 1m2 with 1mm tickness = 1.075 kg
Reviews
There are no reviews yet.